Start-up kit

Specification:

  • Suction pot, 20 litres
  • Level sensor, capacitive
  • Electronic control box (PLC)
  • Suction hose 10 m, Ø 50 mm
  • Suction nozzle 0,7 m, Ø 50 mm
  • Pre-separator cyclone 20 l
  • Central vacuum cleaner

Handling the units:

The suction pipe shall be moved back and forth in order to get an even flow of pellets and air. The suction pot is normally filled in about 2 minutes. When the level sensor stops the vacuum cleaner, the counter weight flap valve will open and the charge of pellets flows down into the boiler room store. After 20 sec, the vacuum cleaner starts automatically.

This cycle is repeated until you shut off the electric power. The pre-separator cyclone separates up to 99% of crubs and dust before it goes into the vacuum cleaner filter bag. The cyclone can also be used for the suction of ashes.

However, never mix wooden dust with hot ashes! The start-up kit contains the basic parts. From this stage it can be extended step by step to a fully automatic system. Check our list of plug-in components.

(details can be changed without notice)

News

All good things are three!

A new three-way valve enables you to use your central vacuum cleaner for pellets tranport, cleaning out ashes or cleaning the house!

>> more

Don’t miss our video about pellet handling. Here you can get some ideas.
 

PELLVAC AB
Box 50
S-287 21 Strömsnäsbruk
Sweden

Phone + 46 - (0)703 - 20 22 91
Phone + 46 - (0)703 - 20 22 71
Fax + 46 - (0)433 - 200 75
Email: info@pellvac.com